iforeo.blogg.se

Fldigi weather station codes
Fldigi weather station codes





fldigi weather station codes
  1. FLDIGI WEATHER STATION CODES SERIAL
  2. FLDIGI WEATHER STATION CODES SOFTWARE
  3. FLDIGI WEATHER STATION CODES LICENSE
  4. FLDIGI WEATHER STATION CODES CRACK

Then gqrx is told to send the signal to the lineout, and dl-fldigi is told to listen to the linein. One way to do this is to physically connect an audio cable from the lineout of the computer to the linein of the same computer. The final step was to connect these two pieces of software.

FLDIGI WEATHER STATION CODES SOFTWARE

Next, I downloaded dl-fldigi, the software to decode the beeps and boops and turn them into telemetry data. It didn’t sound like much, just some digital beeps and boops, but it was still really exciting. This was working fine and I was able to tune into the signal and listen to it. So for the tuning software I was using gqrx, which allows you to input the frequency you want to listen to. I was originally trying to set all of this up on Linux, since the computer we set aside for the ground control station already had Linux on it. Since I was using an SDR, I needed a piece of software to tune the radio. The HackRF One is a software defined radio (SDR), meaning that it plugs into your computer and is tuned by the computer, rather than physical knobs and different circuits within the radio. I was using the HackRF One for my receiving radio. I followed this guide, also on the Pi in the Sky website, to complete this task. Once the software was set up, it had to be configured. The guide for the software setup can be found here. The Pi in the Sky website offers a good tutorial for the setup of the system, going all the way from a blank SD card to a fully set up system. Once I had the hardware in hand and I could legally use it, I had to set it up. We were able to plug the Pi in the Sky board directly into a Raspberry Pi, and this took care of most of the electronics needed for the project. There are many different configurations available for the electronics in the payload of the HAB, but we opted for the Pi in the Sky for its simplicity.

FLDIGI WEATHER STATION CODES SERIAL

The Pi in the Sky takes GPS, altitude, and temperature data and stitches this into a serial stream which can be transmitted to radios listening for this data stream. We opted for the Pi in the Sky system, which integrates all the electronic aspects into one board. Once I could legally transmit the location of the payload, I had to set up the system to do just that. Luckily, we both passed the Technician test, allowing us to start our balloon adventures! So Bill and I drove the hour and a half down to Concord, NH to take the test.

FLDIGI WEATHER STATION CODES LICENSE

This would be needed to set up the payload so it can transmit its location and status using radio waves, and the license is just a useful thing to have. The first step of the process was taking the test to get my HAM radio license.

FLDIGI WEATHER STATION CODES CRACK

I was not able to launch a balloon back when I first became interested in HAB in my sophomore year of high school, but working at WMSI this summer I was able to get another crack at it. This blog will document the process WMSI took in building a HAB payload which can be recovered after reaching 100,000 feet. The challenge of engineering something which can be sent to 100,000 feet and then recovered when it drops back down to Earth is also alluring. Really interesting data can be collected and experiments can be done at the high altitudes that these weather balloons reach. There is so much more to high altitude ballooning than just the awesome pictures though. Some breathtaking photos are being taken by amateurs, which look like they could have been taken during a NASA mission.

fldigi weather station codes

It was originally amazing pictures from near space that got me interested in high altitude ballooning (HAB).







Fldigi weather station codes